Test Id : CUU
Copper, 24 Hour, Urine
    
        Useful For
            
                
                
                    
                    Suggests clinical disorders or settings where the test may be helpful
                
            
    
    Investigation of Wilson disease and obstructive liver disease using a 24-hour urine specimen
    
        Method Name
            
                
                
                    
                    A short description of the method used to perform the test
                
            
    
    Triple-Quadrupole Inductively-Coupled Plasma-Mass Spectrometry (ICP-MS/MS)
    
        NY State Available
            
                
                
                    
                    Indicates the status of NY State approval and if the test is orderable for NY State clients.
                
            
    
    
    
        Reporting Name
            
                
                
                    
                    Lists a shorter or abbreviated version of the Published Name for a test
                
            
    
    
    
        Aliases
            
                
                
                    
                    Lists additional common names for a test, as an aid in searching
                
            
    
    Copper (Cu)
Wilson's Disease
Wilson Disease
    
        Specimen Type
            
                
                
                    
                    Describes the specimen type validated for testing
                
            
    
        Urine
    
        Necessary Information
    
    24-Hour volume (in milliliters) is required.
    
        ORDER QUESTIONS AND ANSWERS
    
    | Question ID | Description | Answers | 
|---|---|---|
| TM7 | Collection Duration (h) | |
| VL4 | Volume (mL) | 
    
        Specimen Required
            
                
                
                    
                    Defines the optimal specimen required to perform the test and the preferred volume to complete testing
                
            
    
    Patient Preparation: High concentrations of barium are known to interfere with this test. If barium-containing contrast media has been administered, the specimen should not be collected for at least 96 hours.
Supplies: Urine Tubes, 10 mL (T068)
Collection Container/Tube: Clean, plastic urine collection container with no metal cap or glued insert
Submission Container/Tube: Plastic urine tube or clean, plastic aliquot container with no metal cap or glued insert
Specimen Volume: 10 mL
Collection Instructions:
1. Collect urine for 24 hours.
2. Refrigerate specimen within 4 hours of completion of 24-hour collection.
3. See Metals Analysis Specimen Collection and Transport for complete instructions.
Additional Information: See Urine Preservatives-Collection and Transportation for 24-Hour Urine Specimens for multiple collections.
    
        Special Instructions
            
                
                
                    
                    Library of PDFs including pertinent information and forms related to the test
                
            
    
    
    
        Forms
    
    If not ordering electronically, complete, print, and send 1 of the following forms with the specimen:
    
        Urine Preservative Collection Options
    
    Note: The addition of preservative or application of temperature controls must occur within 4 hours of completion of the collection.
| Ambient (no additive) | OK | 
| Refrigerate (no   additive) | Preferred  | 
| Frozen (no additive) | OK | 
| 50% Acetic Acid  | OK | 
| Boric Acid | No | 
| Diazolidinyl Urea | No  | 
| 6M Hydrochloric Acid | OK | 
| 6M Nitric Acid | OK | 
| Sodium Carbonate | No | 
| Thymol | No | 
| Toluene | No | 
    
        Specimen Minimum Volume
            
                
                
                    
                    Defines the amount of sample necessary to provide a clinically relevant result as determined by the testing laboratory. The minimum volume is sufficient for one attempt at testing.
                
            
    
    0.4 mL
    
        Reject Due To
            
                
                
                    
                    Identifies specimen types and conditions that may cause the specimen to be rejected
                
            
    
    
    
        Specimen Stability Information
            
                
                
                    
                    Provides a description of the temperatures required to transport a specimen to the performing laboratory, alternate acceptable temperatures are also included
                
            
    
    | Specimen Type | Temperature | Time | Special Container | 
|---|---|---|---|
| Urine | Refrigerated (preferred) | 28 days | |
| Ambient | 28 days | ||
| Frozen | 28 days | 
    
        Useful For
            
                
                
                    
                    Suggests clinical disorders or settings where the test may be helpful
                
            
    
    Investigation of Wilson disease and obstructive liver disease using a 24-hour urine specimen
    
        Clinical Information
            
                
                
                    
                    Discusses physiology, pathophysiology, and general clinical aspects, as they relate to a laboratory test
                
            
    
    The biliary system is the major pathway of copper excretion. Biliary excretion of copper requires an adenosine triphosphate (ATP)-dependent transporter protein. Variants in the gene for the transporter protein cause hepatolenticular degeneration (Wilson disease). Ceruloplasmin, the primary copper-carrying protein in the blood, is also reduced in Wilson disease. Urine copper excretion is increased in Wilson disease due to a decreased serum binding of copper to ceruloplasmin or due to allelic variances in cellular metal ion transporters.
Hypercupricuria (increased urinary copper) is also found in hemochromatosis, biliary cirrhosis, thyrotoxicosis, various infections, and a variety of other acute, chronic, and malignant diseases (including leukemia). Urine copper concentrations are also elevated during pregnancy and in patients taking contraceptives or estrogens.
Low urine copper levels are seen in malnutrition, hypoproteinemias, malabsorption, and nephrotic syndrome. Increased zinc consumption interferes with normal copper absorption from the gastrointestinal tract causing hypocupremia.
    
        Reference Values
            
                
                
                    
                    Describes reference intervals and additional information for interpretation of test results. May include intervals based on age and sex when appropriate. Intervals are Mayo-derived, unless otherwise designated. If an interpretive report is provided, the reference value field will state this.
                
            
    
    0-17 years: Not established
> or =18 years: 9-71 mcg/24 h
    
        Interpretation
            
                
                
                    
                    Provides information to assist in interpretation of the test results
                
            
    
    Humans normally excrete less than 60 mcg/day of copper in the urine.
 
Urinary copper excretion greater than 60 mcg/day may be seen in:
-Wilson disease
-Obstructive biliary disease (eg, primary biliary cirrhosis, primary sclerosing cholangitis)
-Nephrotic syndrome (due to leakage through the kidney)
-Chelation therapy
-Estrogen therapy
-Mega dosing of zinc-containing vitamins
 
Because ceruloplasmin is an acute phase reactant, urine copper is elevated during acute inflammation. During the recovery phase, urine copper is usually below normal, reflecting the expected physiologic response to replace the copper that was depleted during inflammation.
    
        Cautions
            
                
                
                    
                    Discusses conditions that may cause diagnostic confusion, including improper specimen collection and handling, inappropriate test selection, and interfering substances
                
            
    
    No significant cautionary statements
    
        Clinical Reference
            
                
                
                    
                    Recommendations for in-depth reading of a clinical nature
                
            
    
    1. Zorbas YG, Kakuris KK, Deogenov VA, et al. Copper homeostasis during hypokinesia in healthy subjects with higher and lower copper consumption. Tr Elem Electro. 2008;25:169-178
2. Lech T, Sadlik JK. Contribution to the data on copper concentration in blood and urine in patients with Wilson's disease and in normal subjects. Biol Trace Elem Res. 2007;118(1):16-20
3. Rifai N, Horwath AR, Wittwer CT, eds. Tietz Textbook of Clinical Chemistry and Molecular Diagnostics. 6th ed. Elsevier; 2018
4 .Mohr I, Weiss KH. Biochemical markers for the diagnosis and monitoring of Wilson disease. Clin Biochem Rev. 2019;40(2):59-77. doi:10.33176/AACB-18-00014
    
        Method Description
            
                
                
                    
                    Describes how the test is performed and provides a method-specific reference
                
            
    
    The metal of interest is analyzed by triple-quadrupole inductively coupled plasma mass spectrometry.(Unpublished Mayo method)
    
        PDF Report
            
                
                
                    
                    Indicates whether the report includes an additional document with charts, images or other enriched information
                
            
    
    
    
        Day(s) Performed
            
                
                
                    
                    Outlines the days the test is performed. This field reflects the day that the sample must be in the testing laboratory to begin the testing process and includes any specimen preparation and processing time before the test is performed. Some tests are listed as continuously performed, which means that assays are performed multiple times during the day.
                
            
    
    Monday, Thursday
    
        Report Available
            
                
                
                    
                    The interval of time (receipt of sample at Mayo Clinic Laboratories to results available) taking into account standard setup days and weekends. The first day is the time that it typically takes for a result to be available. The last day is the time it might take, accounting for any necessary repeated testing.
                
            
    
    
    
        Specimen Retention Time
            
                
                
                    
                    Outlines the length of time after testing that a specimen is kept in the laboratory before it is discarded
                
            
    
    
    
        Performing Laboratory Location
            
                
                
                    
                    Indicates the location of the laboratory that performs the test
                
            
    
    
    
        Fees :
            
                
                
                    
                    Several factors determine the fee charged to perform a test. Contact your U.S. or International Regional Manager for information about establishing a fee schedule or to learn more about resources to optimize test selection.
                
            
    
    - Authorized users can sign in to Test Prices for detailed fee information.
- Clients without access to Test Prices can contact Customer Service 24 hours a day, seven days a week.
- Prospective clients should contact their account representative. For assistance, contact Customer Service.
    
        Test Classification
            
                
                
                    
                    Provides information regarding the medical device classification for laboratory test kits and reagents. Tests may be classified as cleared or approved by the US Food and Drug Administration (FDA) and used per manufacturer instructions, or as products that do not undergo full FDA review and approval, and are then labeled as an Analyte Specific Reagent (ASR) product.
                
            
    
    This test was developed and its performance characteristics determined by Mayo Clinic in a manner consistent with CLIA requirements. It has not been cleared or approved by the US Food and Drug Administration.
    
        CPT Code Information
            
                
                
                    
                    Provides guidance in determining the appropriate Current Procedural Terminology (CPT) code(s) information for each test or profile. The listed CPT codes reflect Mayo Clinic Laboratories interpretation of CPT coding requirements. It is the responsibility of each laboratory to determine correct CPT codes to use for billing.
CPT codes are provided by the performing laboratory.
                
            
    
    CPT codes are provided by the performing laboratory.
82525
    
        LOINC® Information
            
                
                
                    
                    Provides guidance in determining the Logical Observation Identifiers Names and Codes (LOINC) values for the order and results codes of this test. LOINC values are provided by the performing laboratory.
                
            
    
    | Test Id | Test Order Name | Order LOINC Value | 
|---|---|---|
| CUU | Copper, 24 Hr, U | 5633-3 | 
| Result Id | Test Result Name | Result LOINC Value 
                                        
                                        Applies only to results expressed in units of measure originally reported by the performing laboratory. These values do not apply to results that are converted to other units of measure.
                                     | 
|---|---|---|
| 8590 | Copper, 24 Hr, U | 5633-3 | 
| TM7 | Collection Duration (h) | 13362-9 | 
| VL4 | Volume (mL) | 3167-4 |